🫧Kitchen Sink Soap Dispensers✨

A dish soap bottle beside the faucet takes up valuable space and often leaves water marks or sticky residue on the countertop. This kitchen sink soap dispenser extension kit uses an approximately 100 cm silicone suction tube to connect the countertop pump directly to a large soap bottle stored inside the cabinet.

🔄 1. 360° Rotating Spout

Turn the dispenser spout toward your sponge, sink or cookware. The adjustable direction makes dispensing convenient from either side.

🧴 2. Connects Directly to a Large Soap Bottle

The extension tube reaches directly into a full-size dish soap container, eliminating the need for a traditional small refill reservoir.

✨ 3. Helps Clear the Countertop

Store the large detergent bottle inside the cabinet beneath the sink, reducing countertop clutter and helping the washing area look cleaner.

👆 4. Simple Press-to-Dispense Operation

There is no need to lift, open or tilt a soap bottle. Press the pump with one hand to dispense soap onto a sponge, brush or dish.

📏 5. Approximately 100 cm Extension Tube

The flexible one-metre silicone tube provides plenty of reach and can be arranged around the available space inside the cabinet.

🚫 6. Less Frequent Refilling

Using a large soap bottle reduces the need to repeatedly remove a small container, pour in detergent and clean up accidental spills.

Step 1: Check the Mounting Hole
Make sure the sink or countertop has a suitable dispenser hole and enough space underneath for a large soap bottle.

Step 2: Install the Pump
Insert the threaded pump section through the mounting hole from above. Install the washer and fastening nut underneath, then tighten securely.

Step 3: Connect the Suction Tube
Push one end of the silicone tube firmly onto the suction connection at the bottom of the pump.

Step 4: Insert It into the Soap Bottle
Feed the other end of the tube through the bottle-neck holder and place it inside the large detergent bottle.

Step 5: Position the Tube
Make sure the tube reaches close to the bottom of the bottle without pressing tightly against it.

Step 6: Prime the Pump
Press the pump several times to remove air from the tube. Continue pressing until the soap reaches the pump and begins dispensing.

Step 7: Adjust the Spout
Rotate the spout toward the sponge, sink or cookware, then dispense as needed.

• Rinse and dry the tube before the first installation.
• Avoid sharp bends, knots or kinks in the tube.
• Keep the suction end submerged in the liquid.
• Flush the tube with warm water before changing liquids.
• Do not use liquids containing particles or hardened residue.
• Very thick soap may require additional presses during priming.

Customer Reviews ⭐

What’s in the Box 📦

• 1 × Silver dispenser pump
• 1 × Countertop mounting assembly
• 1 × Approximately 100 cm silicone suction tube
• 1 × Bottle-neck tube holder

* Dish soap and the soap bottle are not included.